Quick guide

First, enter the type designation or article number of the pump to be replaced into the search box on the left.

Operating mode

This mode is active when the pump starts.

The pump runs in the default setting - a standard characteristic curve.

The symbols above the LEDs indicate whether individual functions are active or inactive.

Programming mode for setting the required characteristic curve

To start programming mode, press and hold both green buttons simultaneously for approximately 3 seconds.

Programming mode is activated when all LEDs flash green three times.

Activate or deactivate individual functions by pressing the lower green button.

Change the LED position by pressing the upper green button.

Exit programming mode and save the settings

Now briefly press both green buttons to save your settings.

The pump displays the selected LED code for five seconds. All LEDs flash three times and the pump returns to operating mode.

If an invalid LED code has been entered and saved, the upper LED briefly lights up red during the flashing phase.

Cancel programming mode without saving the settings

Hold down both green buttons for five seconds and then release them.

The pump returns directly to operating mode without saving.